|
There was only one step in the procedures that I would change or note for
others. Page 6-6 Step 9 tells you to 'Finish riveting VS-1014-L and -R
Rear Spar Caps to the rear spar'. I like squeezing rivets when ever
possible and in the next
to last picture, there is one rivet missing. That is because you can not
get a squeezer into that hole because of the Hinge Bracket. Until this
step, I did not own a 3/32" cup rivet set. A small point but if you
do not set this rivet before riveting the bracket, you will also need one.
It does not come with the Avery -10 tool kit.
|
